Sunsole

Solar Water Heater - FPC

Specifications
BrandSUNSOLE
Description

We are successfully engaged in providing a wide range of FPC Solar Water Heater.

FPC Water Heaters: In a typical flat-plate collector FPC-based solar water heater in this type the solar radiation is absorbed by flat plate collectors which consist of an insulated outer metallic box covered on the top with a glass sheet. A glass cover (called glazing) on top and a dark-colored absorber plate on the bottom. The sides and bottom of the collector are usually insulated to minimize heat loss. Inside there are blackened metallic absorber selectively coated sheets with built-in channels or riser tubes to carry water, the absorber absorbs the solar radiation and transfers the heat to the flowing water

Technical Specification for FPC:

  • Section: 1.2 mm thickness Aluminum
  • Back sheet: 0.46 mm thick Aluminum
  • Insulation: Fiber Glass Wool
  • Foil: 0.05 thick Aluminum
  • Flat Plate Collector Fins: Ultrasonic welded with insulant coating copper pipe 24 SWG, Aluminum strip 0.20 mm
  • Header Pipe: Copper 24 SWG
  • Glazing: 1000*2000*4 mm Clear toughened glass
  • Glass Beading: EPDM Rubber
  • Fasteners: Stainless Steel
  • Grommets: EPDM Rubber
  • Flaggers: Brass
  • Finishing: Powder Coating
  • Storage Tank: C.R.C.A Sheet with prime guard coating
  • Insulation: 50 mm Thick PUF
  • Support Structure: Mild Steel with powder-coated
  • Capacity Available: 100, 125, 150, 200, 250,300,500 Up to 1000 LPD

Tank:

Inner tank: 2mm H.R sheet with Co2 welding inside coated with prime guard coating / 3mm for pressurized systems.

Side Dish: 2.5mm for Non Pressurized / 3.5mm for PRD

Connecting pipes: SS.

Insulation: 50 mm thick PUF.

Outer Cladding: Pre-coated laminated sheet (color: Half white) / Mirror finish

End Caps: GI with PP coating.

Support Structure: GI with powder coating.